We exclusively supply customers with prior business registration

Rafter bracket Herkules 48/900 B for rafter widths up to 120 cm

Rafter bracket Herkules 48/900 B for rafter widths up to 120 cm

(1 Reviews)

SKU: 51101
GTIN: 4260165022125
Category: Mounting solutions
Manufacturers: Dura-Sat

Reviews

Documents

One of the best rafter brackets on the market. Withstands a load of 1000 Nm, almost twice as much as comparable brackets. Quick installation. Variable rafter spacing (clear width between the rafters) 55 - 120 cm. Height 90 cm, Ø 48 mm with pole cap. Improved design for cable feed-through!

If not in stock, item will be ordered directly from the distributor after receipt of your order. Delivery time approx. 7-10 days.

95,80 €

excl. 19% VAT , plus (GLS-Paket)

1 pc(s) In stock
Delivery time: 1 - 5 Workdays (DE - int. shipments may differ)

pc(s)

Description
Reviews

Thanks to the latest technology, this rafter bracket has a 100% - 400% larger contact surface than comparable brackets (variants with only one cross tube without a supporting bracket in the direction of the roof pitch). This drastically increases the frictional force. In addition, over 2000 hardened teeth grip into the cone of the pole, ensuring an immovable hold that does not change its position even during storms. Nevertheless, the pole can be released and repositioned. Max. Wind load 1000 Nm (almost twice as high as comparable rafter brackets). The bracket is supplied with a safety nut that will not come loose even under constant load on the roof. This development was designed for maximum ease of installation. Ultra-fast and easy installation. Except for 1 screw, this bracket is completely pre-assembled. Thanks to the double-slide technology, moving and adjusting the pole to the desired position has become even easier. The predetermined angle of the 2 cones generates maximum contact pressure. Thanks to the narrow cone on the pole, the bracket is ideally suited for all roof coverings supplied on the market. The pole is hot-dip galvanized and therefore offers the best protection against weather and environmental influences.

Technical data

For mounting between 2 rafters
Variable rafter spacing 90 - 120 cm (clear width between the rafters)
(The smaller value results from the length of the two square tubes, which are pushed in as far as they will go. If these are shortened, the rafter bracket can also be used for smaller rafter spacings.)
Pole length 90 cm
Pole Ø 48 mm
With pole cap
Infinitely variable inclination between 20 - 160 ° (corresponding to roof pitch of 0 - approx. 70 °)
Earthing screw
Max. Wind load 1000 Nm

6 additional construction screws / wood construction screwsare requiredfor fastening to the rafters

Attention! The lower end of the mast is no longer closed as before, but open (see Fig. 5) and can therefore be used as a cable duct.

PDF | Datasheet

Datenblatt_51101

Manufacturer information:

Dura-Sat

, ,
https://www.durasat.de/

Shipping weight:	9,00 kg
Item weight:	9,00 kg
Dimensions(LxWxH) ( Length × Width × Height ):	103,00 × 10,00 × 22,50 cm

Average item rating

All reviews:

Total entries: 1

Stabiler Sparrenhalter zum fairen Preis
Sehr solider Sparrenhalter auch bei 110cm Sparrenabstand, leichte Montage, gute Verarbeitung. Erdungsanschluss vorhanden. Schraubensatz für Sparrenmontage muss separat erworben werden.

Toralf B , 25.08.2016

Total entries: 1